LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Mustang Base, 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1727 (Front Suspension - Four Wheel Drive (4WD) -- F250-F550 Super Duty) >> Removal And Installation >> Wheel Studs >> Removal

Wheel Studs: Removal

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the wheel and tire. For additional information, refer to WHEELS AND TIRES article.
    2. CAUTION: Do not allow the caliper assembly to hang from the brake hose or damage to the hose may occur.
  2. Remove the 2 caliper anchor plate bolts and position the caliper assembly aside.
    • Support the caliper assembly using mechanic's wire.
  3. Index-mark and remove the brake disc.
    4. Fig 1: Identifying Index-Mark And Brake Disc
    GF0006166Courtesy of FORD MOTOR CO.
  4. Using the special tool, remove and discard the wheel stud.
Fig 2: Removing Wheel Stud Using Special Tool
GF0006167Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals