LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Mustang Base, 2D Convertible, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 1717 (Rear Drive Axle/Differential - DANA S110 & S130 -- F450-F550 Super Duty) >> Disassembly And Assembly >> Differential Case and Ring Gear >> Assembly >> S130 axles

S130 axles

WARNING: This page is about a different car, the 2007 Ford F550 Super Duty and 2007 Ford F450 Super Duty. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Lubricate both sides of the thrust washer with axle lubricant.
    Fig 1: Identifying Inner Side Gear And Thrust Washer
    G03918581Courtesy of FORD MOTOR CO.
  1. Install the inner side gear thrust washer and inner side gear.
  2. Position the full shaft pinion shaft in the shaft bores of the pinion case. Make sure it is the side that does not have lockpin holes.
    • Locate the lockpin holes.
    • Position the side pinion and thrust washer.
    • Start the full shaft into the differential case.
    Fig 2: Positioning Full Shaft Pinion Shaft In Shaft Bores Of Pinion Case
    GF0006430Courtesy of FORD MOTOR CO.
  3. Install the opposite side pinion and washer.
    • Position the thrust washer and pinion.
    • Push the shaft through the pinion and washer.
    Fig 3: Installing Full Shaft Pinion Shaft Opposite Side Of Pinion And Washer
    GF0006431Courtesy of FORD MOTOR CO.
  4. Install a side pinion and thrust washer on the halfshaft side.
    1. Position the side pinion and thrust washer.
    Fig 4: Installing Side Pinion And Thrust Washer On Halfshaft Side
    GF0006432Courtesy of FORD MOTOR CO.
  5. Install the halfshaft so the pin is facing upward and push the shaft in until it stops.
    Fig 5: Installing Halfshaft
    GF0006433Courtesy of FORD MOTOR CO.
  6. Position the halfshaft in the case.
    • Align the halfshaft in the slot.
    • Align the lockpin hole with the halfshaft.
    Fig 6: Aligning Halfshaft In Slot
    GF0006434Courtesy of FORD MOTOR CO.
  7. Install the lockpin.
    Fig 7: Installing Lockpin
    GF0006435Courtesy of FORD MOTOR CO.
  8. Repeat Steps 6 and 7 to install the opposite halfshaft.
    9. NOTE: There is no thrust washer in this location.
    Fig 8: Installing Outer Side Gear
    GF0006421Courtesy of FORD MOTOR CO.
  9. Install the outer side gear.
  10. Remove the locating dowels from the ring gear.
    Fig 9: Removing Locating Dowels From Ring Gear
    GF0006436Courtesy of FORD MOTOR CO.
  11. Install the dowels over the lockpins.
    Fig 10: Installing Dowels Over Locking Pins
    GF0006437Courtesy of FORD MOTOR CO.
  12. Lower the ring gear on the case aligning the locking dowels.
    Fig 11: Lowering Ring Gear On Case
    GF0006438Courtesy of FORD MOTOR CO.
  13. Install the 12 ring gear bolts finger tight.
    Fig 12: Installing Ring Gear Bolts
    GF0006417Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals