LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Focus ZTS, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 2221 (Electronic Engine Control System - 6.0L (99P E Series & 99P F450/550) Diesel Engine - F250-F550 Super Duty) >> Removal And Installation >> Barometric Pressure (BARO) Sensor >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Make sure the ignition switch is in the OFF position prior to working on the electronic engine controls.
  1. Turn the ignition switch to the OFF position.
    2. CAUTION: Use care when removing the instrument panel steering column cover or damage to the cover locating tab can occur.
  2. Remove the instrument panel steering column cover.
    • Unlock the retainers.
    • Remove the instrument panel steering column cover.
    3. Fig 1: Identifying Instrument Panel Steering Column Cover And Retainers
    GF0006061Courtesy of FORD MOTOR CO.
  3. Remove the barometric pressure (BARO) sensor.
    • Disconnect the BARO sensor electrical connector.
    • Release the clip and remove the BARO sensor.
    4. Fig 2: Locating BARO Sensor & Electrical Connector
    GF0006062Courtesy of FORD MOTOR CO.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals