LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Focus LX, Standard >> Repair and Diagnosis >> Brakes >> Traction Control >> Anti-Lock Brake System >> Diagnostic Tests >> Test B1: DTC C1095 - Abs Hydraulic Pump Motor Circuit Failure (Abs)

Test B1: DTC C1095 - Abs Hydraulic Pump Motor Circuit Failure (Abs)

  1. Turn ignition on. Check ABS pump for continuous operation. If pump motor runs continuously, replace ABCM. If pump motor does not run continuously, go to next step.
  2. Turn ignition off. Disconnect ABCM connector (C385). Using DVOM, measure voltage between ABCM connector terminal No. 9 (Red wire) and ground. See WIRING DIAGRAMS . If voltage is greater than 10 volts, replace ABCM. If voltage is less than 10 volts, repair Red wire.
scientia non olet · About LEMON Manuals