Vehicles with rear disc brakes
- Install the wheel hub nut to 35 Nm.
- Tighten the wheel hub retaining nut to 235 Nm.
- Install the rear brake disc. See DISC BRAKES & DRUM BRAKES .
CAUTION:
Avoid any impact on the wheel speed sensor ring.
CAUTION:
Make sure the wheel speed sensor ring is clean.
CAUTION:
Avoid any contact between the wheel speed sensor ring and a magnetic surface.
CAUTION:
The wheel hub retaining nut can be re-used four times, mark the wheel hub retaining nut.
NOTE:
Do not fully tighten the wheel hub retaining nut at this stage.
CAUTION:
Rotate the hub assembly 10 times in the opposite direction when tightening the wheel hub retaining nut to prevent damage to the bearing.