LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Excursion 7.3 F, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 98 (Front Suspension - Four Wheel Drive (4WD) -- F250-F550 Super Duty) >> Removal And Installation >> Radius Arm >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2003 Ford Pickup, 2003 Ford F550 Super Duty, 2003 Ford F450 Super Duty, and 2003 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure can result in major service expense. Install new parts with the same part number or an equivalent part if installation of a new part is necessary. Do not use a replacement part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of correct retention of theses parts.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING .
  2. Remove the wheel and tire assembly. For additional information, refer to WHEELS AND TIRES .
  3. Using a suitable jack, support the front axle assembly.
  4. Remove the radius arm-to-frame bracket nut and bolt.
    Fig 1: Removing/Installing Radius Arm-To-Frame Bracket Nut And Bolt
    G03917894Courtesy of FORD MOTOR CO.
  5. Remove the radius arm-to-axle nuts and bolts.
    Fig 2: Removing/Installing Radius Arm-To-Axle Nuts And Bolts
    G03917895Courtesy of FORD MOTOR CO.
  6. Remove the radius arm assembly.
  7. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals