LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Excursion 7.3 F, RWD >> Repair and Diagnosis >> Electrical >> Gauges >> Instrument Panels - Analog - Excursion & F250/F350 Super Duty Pickups >> System Tests >> Test R: Right Turn Signal Indicator Light Inoperative

Test R: Right Turn Signal Indicator Light Inoperative

  1. Turn ignition switch to LOCK position. Check right turn indicator bulb for continuity. See INSTRUMENT CLUSTER  under REMOVAL & INSTALLATION. If bulb is okay, go to next step. If bulb is not okay, replace bulb.
  2. Disconnect instrument cluster harness connector C250b. Turn ignition switch to RUN position. Place multifunction switch in right turn signal position. Measure voltage between ground and terminal No. 14 (White/Light Blue wire) at instrument cluster harness connector C250b. See Figure. If voltage fluctuates between 0-10 volts, go to next step. If voltage does not fluctuate 0-10 volts, repair open in White/Light Blue wire.
  3. Turn ignition switch to LOCK position. Disconnect instrument cluster harness connector C250c. Measure resistance between ground and terminal No. 12 (Black wire) at instrument cluster harness connector C250c. See Figure. If resistance is 5 ohms or less, replace instrument cluster. If resistance is more than 5 ohms, repair open in Black wire. Ground point is behind bottom of left cowl panel.
scientia non olet · About LEMON Manuals