LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Excursion 7.3 F, RWD >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brakes & Drum Brakes >> Removal & Installation >> Front Brake Rotor >> Installation (Van)

Installation (Van)

  1. Apply grease and pack wheel bearings. Install inner bearing and NEW grease seal. Position rotor. Install outer wheel bearing, and bearing retainer washer. Position spindle nut.
  2. To seat bearings, while rotating rotor clockwise, tighten spindle nut to 29.5 ft. lbs. (40 N.m). Loosen spindle nut 2 full turns. While rotating rotor clockwise, tighten spindle nut to 17-24 ft. lbs. (23-34 N.m). Back off spindle nut 175 degrees. To complete tightening procedure, rotate hub and rotor clockwise while tightening spindle nut to 17 INCH lbs. (2 N.m).
  3. To complete installation, install spindle nut retainer, NEW cotter pin, and grease cap. Install caliper anchor plate and caliper. Tighten bolts. See TORQUE SPECIFICATIONS .
scientia non olet · About LEMON Manuals