LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Excursion 7.3 F, RWD >> Repair and Diagnosis (Single Page) >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Removal, Overhaul & Installation - Diesel - 7.3L (99F E Series & 99F F450/550) >> Air Induction >> Exhaust BACKPRESSURE Valve >> Removal & Installation (Econoline)

Removal & Installation (Econoline)

  1. Remove engine cover. Remove turbocharger heat shield.
  2. Loosen marmon clamp and pull exhaust outlet pipe away from turbocharger. See Fig 1.
  3. Disconnect the control rod from exhaust backpressure valve and remove bolts retaining exhaust backpressure valve to turbocharger.
  4. To install, reverse removal procedure. Tighten exhaust backpressure valve bolts to specification. See TORQUE SPECIFICATIONS . Using the Spring Gauge, adjust the control rod length until 10 lbs. (4.5 kg) of force is required to fully close the exhaust backpressure valve. See Fig 2.
Fig 1: Removing & Installing Exhaust Connections At Turbocharger
G00248192Courtesy of FORD MOTOR CO.
Fig 2: Adjusting Control Rod Tension
G97G03799Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals