LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Excursion 7.3 F, RWD >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> Engine - 7.3L (99F E Series & 99F F450/550) V8 Turbo Diesel - VIN F >> Removal & Installation >> Flywheel >> Removal

Removal & Installation: Flywheel: Removal

  1. On A/T models, a standard type flywheel is used. On M/T models a dual mass flywheel is used. Dual mass flywheel is consists of 2 flywheels. See Figure. On all models, remove transmission. For A/T, see appropriate TRANSMISSION REMOVAL & INSTALLATION article in TRANSMISSION SERVICING. For M/T, see appropriate CLUTCHES article in TRANSMISSIONS.
  2. On A/T models, remove flywheel-to-crankshaft bolts and flywheel. On M/T models, remove clutch assembly from flywheel. Remove 2 flywheel-to-crankshaft bolts and install guide studs. Remove remaining flywheel-to-crankshaft bolts. Remove reinforcing plate, secondary flywheel and primary flywheel. Remove secondary flywheel bolts and separate primary flywheel from secondary flywheel.
scientia non olet · About LEMON Manuals