LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Excursion 7.3 F, RWD >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> Engine - 7.3L (99F E Series & 99F F450/550) V8 Turbo Diesel - VIN F >> Removal & Installation >> Crankshaft Rear Oil Seal >> Installation

Crankshaft Rear Oil Seal: Installation

  1. Ensure sealing surfaces are clean and all silicone sealant is removed. Apply silicone sealant to engine rear cover sealing surface. Install rear engine cover. Apply silicone sealant to crankshaft rear oil seal retaining ring and threads of crankshaft rear oil seal retaining bolts.
  2. Using Crankshaft Seal Replacer (T94T-6701-AH3), Crankshaft Seal Replacer (T94T-6701-AH4), Handle (T80T-4000-W) and guide pins, install crankshaft wear ring (if equipped) and crankshaft rear oil seal.
  3. Install and tighten crankshaft rear oil seal retaining bolts. To install remaining components, reverse removal procedure.
scientia non olet · About LEMON Manuals