LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Excursion 7.3 F, RWD >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> Engine - 7.3L (99F E Series & 99F F450/550) V8 Turbo Diesel - VIN F >> Removal & Installation >> Camshaft Bearings >> Installation

Camshaft Bearings: Installation

  1. To install, reverse removal procedure. Ensure oil hole in camshaft bearing aligns with oil hole in cylinder block.
    CAUTION: Front camshaft bearing must be installed to specified installed depth to prevent damage to engine components.
  2. Install front camshaft bearing in cylinder block so front camshaft bearing installed depth is .020-.050" (.51-1.27 mm). Front camshaft bearing installed depth is measured from face of cylinder block to front edge of front camshaft bearing. Install NEW cylinder block camshaft core plug. To install remaining components, reverse removal procedure.
scientia non olet · About LEMON Manuals