LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Excursion 7.3 F, RWD >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> Engine - 7.3L (99F E Series & 99F F450/550) V8 Turbo Diesel - VIN F >> Engine Oiling >> Low-Pressure Oil Pump >> Reassembly & Installation

Reassembly & Installation

  1. To reassemble, reverse disassembly procedure. Ensure components are installed in original location.
  2. To install, reverse removal procedure using "O" ring. Ensure outer gerotor is lubricated with engine oil before installing low-pressure oil pump body. Install and tighten low-pressure oil pump body-to-front cover bolts.
  3. Manufacturer recommends installing NEW crankshaft front seal any time vibration damper is removed. For proper installation procedure of crankshaft front seal, see CRANKSHAFT FRONT SEAL  under REMOVAL & INSTALLATION.
Fig 1: Locating Low-Pressure Oil Pump Components
G97C03801Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals