LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Excursion 7.3 F, RWD >> Repair and Diagnosis (Single Page) >> Drivelines & Axles >> Differentials & Drive Axles >> Differentials - DANA 50, 60, 80 & Ford 10.50" - Excursion & "F" Series Super Duty >> Torque Specifications

Torque Specifications

TORQUE SPECIFICATIONS

Application Ft. Lbs. (N.m)
2-Piece Differential Case Half Bolts (10.50") 90 (122)
ABS Sensor Bolt 35 (47)
Axle-To-Hub Bolt (Model 80) 81 (110)
Bearing Cap Bolts
Dana Models 80 (108)
Ford 10.50" 88 (119)
Drive Shaft Bolt 76 (103)
Fill Plug
Dana 80 20-31 (27-42)
Ford 10.50" 15-30 (20-40)
Housing Cover Bolt
Dana 50 & 60 35 (47)
Dana 80
F350 35 (47)
F450 & F550 45 (61)
Ford 10.50" 29-39 (38-52)
Pinion Flange Nut
Dana 50 & 60 (1) 160-500 (217-678)
Dana 80 470 (637)
Pinion Shaft Lock Bolt (Ford 10.50") 23 (30)
Rear Axle Housing Vent Bolt (10.50") 8-18 (11-24)
Ring Gear Bolt
Dana 50 100 (136)
Dana 60 135 (183)
Dana 80 220 (298)
Ford 10.50" 101-120 (136-163)
Shock Absorber Bolts (Ford 10.50") 47 (63)
Spring Plate Bolts (Ford 10.50") 186 (251)
Stabilizer Bar Bolt 35 (47)
Trackbar Nut
Dana 50 & 60 129 (175)
"U" Bolt Nut 99 (134)
Wheel Lug Nut 140 (190)
INCH lb. (N. m)
Fill Plug (Dana 50 & 60) 27 (3)
(1) Measure and record pinion bearing preload prior to removing pinion nut. After installing pinion nut, tighten nut while checking preload. Tighten nut to original preload reading, then tighten an additional 5 INCH lbs. (.6 N.m).