Ignition Switch: Installation
WARNING: This page does not describe the selected car, but rather 20 other vehicles, including the 2001 Mercury Villager, 2001 Mercury Mountaineer, 2001 Lincoln Navigator, 2001 Ford Windstar, and 2001 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
Ensure ignition lock is in RUN position. Slot in actuator housing should be aligned with mark on steering column casting. Align pin on ignition switch with slot in actuator housing. Connect ignition switch electrical connector, and tighten retaining screws to specification. See TORQUE SPECIFICATIONS . To complete installation, reverse removal procedure.
Turn ignition lock cylinder to LOCK position. Place actuator rod on switch. Place switch on column studs while aligning rod hole in ignition switch with actuator rod. Tighten retaining nuts to specification. See TORQUE SPECIFICATIONS . Check switch for proper operation in all positions. To complete installation, reverse removal procedure.