Removal (Excursion & Super Duty Pickup - 4WD)

Raise and support vehicle. Remove wheel. Remove anchor plate and caliper assembly. See DISK BRAKE CALIPERS & PADS . On models with single rear wheels, remove rotor. On models with dual rear wheels, remove hub plate extender nuts, and remove hub extender plate. See Fig 1. Remove rotor.

NOTE: If excessive force is used when removing rotor, it should be checked for lateral runout prior to installation. See ROTOR under OVERHAUL.

Fig 1: View Of Front Hub & Rotor Assembly (Super Duty Pickup - 4WD With Dual Rear Wheels)

Courtesy of FORD MOTOR CO.