Removal & Installation: Flywheel: Inspection
- On A/T models, inspect flywheel and starter ring for damage. Replace flywheel if damaged.
- On M/T models, inspect secondary flywheel for grooves or damaged areas in clutch disc area. Resurface secondary flywheel as necessary. Replace secondary flywheel if secondary flywheel thickness is less than 1.41" (35.8 mm) after machining, or more than .060" (1.52 mm) is machined from original thickness on secondary flywheel.
CAUTION:
DO NOT use secondary flywheel if secondary flywheel thickness is less than 1.41" (35.8 mm) after machining, as this may cause damage to primary flywheel.