LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Excursion 7.3 F, 4WD >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> Engine - 7.3L (99F E Series & 99F F450/550) V8 Turbo Diesel - VIN F >> Removal & Installation >> Crankshaft Rear Oil Seal >> Removal

Crankshaft Rear Oil Seal: Removal

  1. Remove transmission. For A/T, see appropriate TRANSMISSION REMOVAL & INSTALLATION article in TRANSMISSIONS. For M/T, see appropriate CLUTCHES article in TRANSMISSIONS. On M/T models, remove flywheel. See FLYWHEEL . On A/T models, remove bolts, spacer and flexplate. On all models, remove flywheel adapter housing retaining rings. Remove flywheel front adapter, using care not to damage alignment dowel pins.
  2. Remove crankshaft rear oil seal retaining bolts from rear of cylinder block. Remove crankshaft rear oil seal. Remove engine rear cover retaining bolts and rear cover. Clean cover sealing surfaces. Clean crankshaft rear oil seal surfaces. If equipped with crankshaft wear sleeve, remove crankshaft wear sleeve using Crankshaft Service Set (T94T-6701-AH) and Handle (T80T-4000-W).
scientia non olet · About LEMON Manuals