LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Excursion 7.3 F, 4WD >> Repair and Diagnosis (Single Page) >> Engine Mechanical >> Mechanical >> Engine - 7.3L (99F E Series & 99F F450/550) V8 Turbo Diesel - VIN F >> Engine Oiling >> Oil Cooler Assembly >> Removal & Disassembly

Removal & Disassembly

  1. Disconnect negative cables. Drain cooling system. Raise and support vehicle.
  2. Disconnect exhaust pipe at turbocharger for access to oil cooler if necessary. Remove oil cooler front header-to-cylinder block bolts. See Figure. Drain engine oil and remove oil filter.
  3. Disconnect retainer and cable from cylinder block heater. Cylinder block heater is located on driver-side rear corner of cylinder block, just below exhaust manifold, near oil filter.
  4. Remove oil cooler rear header-to-cylinder block bolts. See Figure. Remove oil cooler assembly and gaskets. Perform oil cooler leakage test to ensure oil cooler is not defective.
scientia non olet · About LEMON Manuals