LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Excursion 7.3 F, 4WD >> Repair and Diagnosis (Single Page) >> Drivelines & Axles >> Locking Hubs >> Four-Wheel Drive Systems (ESOF) - Excursion & F250-F550 Super Duty >> Diagnosis & Testing >> Equipment Hook-Up

Equipment Hook-Up

  1. Ensure ignition switch is in OFF position. Select proper program card for scan tool for vehicle application. With scan tool facing away from you, insert program card into slot on scan tool. Ensure program card is properly inserted into scan tool or scan tool will not operate.
  2. Connect scan tool to 16-pin DLC. DLC is located below driver's side of instrument panel, to right of steering column.
  3. Turn ignition switch to ON position. Scan tool automatically performs a initialization test. Initialization TEST checks scan tool memory and verifies vehicle interface module matches program card for scan tool. If an error message is displayed on scan tool, refer to scan tool operator's manual for system messages.
  4. Menu item VEHICLE AND ENGINE SELECTION should be highlighted on scan tool. Press trigger to select VEHICLE AND ENGINE SELECTION.
  5. Rotate dial on scan tool to menu item SELECT NEW VEHICLE MODEL AND YEAR. Press trigger to select VEHICLE AND ENGINE SELECTION. Select model year, vehicle and engine size by rotating dial to highlight selection, and then press trigger to select. If selected vehicle is not displayed, repeat this step.
scientia non olet · About LEMON Manuals