LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Excursion 6.8 S, RWD >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Disc Brakes & Drum Brakes >> Removal & Installation >> Parking Brake (Explorer) >> Removal & Installation (Front Cable & Conduit)

Removal & Installation (Front Cable & Conduit)

  1. Remove the parking brake control. For additional information, refer to REMOVAL & Installation (Control) .
  2. Remove the parking brake anchor pin from the parking brake control (2780).
    G00593898Courtesy of FORD MOTOR CO.
  3. Bend the takeup spool tab up.
    G00593899Courtesy of FORD MOTOR CO.
  4. Remove the front parking brake cable and conduit housing.
    1. Compress the front parking brake cable and conduit-to-parking brake control clip.
    2. Remove the front parking brake cable and conduit housing.
    G00593900Courtesy of FORD MOTOR CO.
  5. To install, reverse the removal procedure.
    • Make sure cable is routed through loop on takeup spool.
scientia non olet · About LEMON Manuals