Wheel Spindle - F-250, F-350: Installation

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Tighten the ball joint nut further, if necessary, in order to insert a new cotter pin.

Fig 1: Installing Castellated Nut

Courtesy of FORD MOTOR CO.

Fig 2: Installing Pinch Bolt

Courtesy of FORD MOTOR CO.

Fig 3: Installing Tie Rod End

Courtesy of FORD MOTOR CO.

Fig 4: Installing ABS Sensor Harness Retaining Bolt

Courtesy of FORD MOTOR CO.

Fig 5: Installing Front Brake Disc Shield

Courtesy of FORD MOTOR CO.

Using new fasteners, follow the removal procedure in reverse order.
Check the front end alignment. For additional information, refer to SUSPENSION SYSTEM -- GENERAL INFORMATION .