Removal & Installation (Villager - With Key)
WARNING: This page does not describe the selected car, but rather 20 other vehicles, including the 2001 Mercury Villager, 2001 Mercury Mountaineer, 2001 Lincoln Navigator, 2001 Ford Windstar, and 2001 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect battery ground cable. Remove lower and upper steering column shroud. Turn ignition switch on. Remove 2 screws and key-in-reminder switch.
- Place 1/8" (3.18 mm) diameter wire pin or small drift in access hole in lock housing under ignition switch lock cylinder. Depress retaining pin while pulling on ignition switch lock cylinder. To install, reverse removal procedure.