Exhaust Manifold - LH: Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Left Exhaust Manifold Torque Sequence

Courtesy of FORD MOTOR CO.

NOTE: Start installing the bolts with the second bolt from the rear on the top. The hole diameter is smaller, therefore allowing alignment of the remaining bolts.

NOTE: When installing the exhaust manifolds, only use prevailing torque hex flange bolts with an interference fit.

NOTE: Apply anti-seize lubricant to the bolt threads prior to installing the bolts.

Install the LH exhaust manifold and tighten the bolts in the sequence shown.
- Tighten to 38 Nm (28 lb-ft).

NOTE: Apply anti-seize lubricant to the bolt threads prior to installing the bolts.

Install the 2 LH exhaust manifold-to-turbocharger adapter pipe nuts.
- Tighten to 27 Nm (20 lb-ft).
Connect the EP sensor tube to the exhaust manifold.
- Tighten to 30 Nm (22 lb-ft).