LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Econoline E150, Van Passenger, 5.4 L >> Repair and Diagnosis >> Drivelines & Axles >> Differentials & Drive Axles >> Differentials - Rear - 8.8" & 9.75" Ring Gear - "E" Series Vans >> Removal & Installation >> Pinion Flange & Oil Seal >> Removal

Pinion Flange & Oil Seal: Removal

  1. Raise and support vehicle. Scribe alignment marks on companion flange and drive shaft end yoke for installation reference. Remove driveshaft-to-pinion flange bolts, and wire drive shaft aside. Using an INCH-lb. torque wrench, measure and record torque required to rotate pinion through several revolutions.
  2. Mark companion flange or end yoke in relation to pinion shaft for installation reference. Hold pinion flange and remove pinion nut. Using Pinion Flange Puller (TOOL-4858-E), remove companion flange. Using screwdriver, remove pinion seal.
scientia non olet · About LEMON Manuals