LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SVT >> Repair and Diagnosis >> External Pages >> Different car >> Section 81 (Engine Removal, Overhaul & Installation -- ECONOLINE, Excursion & F250-F550 Super Duty - Diesel 7.3L (99F E Series & 99F F450/550)) >> Fuel System >> Fuel Injectors >> Installation

Fuel Injectors: Installation

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2002 Ford RV Cutaway, 2002 Ford Pickup, 2002 Ford F550 Super Duty, 2002 Ford F450 Super Duty, and 2002 Ford Excursion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Apply Threadlock 262 (E2FZ-19554-B) to injector sleeve. See Fig 1. DO NOT apply threadlock to tapered areas. Install sleeve using Injector Sleeve Replacer (303-D109) and rubber mallet. See Fig 2. Clean any residual sealant from sleeve and injector bore.
    Fig 1: Applying Threadlock To Injector Sleeve
    G00011966Courtesy of FORD MOTOR CO.
    Fig 2: Installing Fuel Injector Sleeve
    G95G35861Courtesy of FORD MOTOR CO.
    Fig 3: Installing New "O" Rings On Fuel Injector
    G99A02481Courtesy of FORD MOTOR CO.
  2. Inspect injector bore. Injector bore must be completely clean. If reusing fuel injector, replace "O" rings. See Fig 3. Lubricate injector and "O" rings with engine oil. Install injector in head. Do not strike top of injector to install or seat injector. Using Injector Replacer (303-492), seat fuel injector. See Fig 4.
  3. Install oil deflector and outer injector retaining bolt. Tighten retaining bolt to 106 INCH lbs. (12 N.m). Connect electrical connector to fuel injector. Install valve cover. Tighten valve cover bolts to specification. See TORQUE SPECIFICATIONS . To complete installation, reverse removal procedure.
Fig 4: Installing Fuel Injector Using Injector Replacer
G95I35863Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals