LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SVT >> Repair and Diagnosis >> External Pages >> Different car >> Section 81 (Engine Removal, Overhaul & Installation -- ECONOLINE, Excursion & F250-F550 Super Duty - Diesel 7.3L (99F E Series & 99F F450/550)) >> Computerized Engine Controls >> Powertrain Control Module >> Removal & Installation

Removal & Installation

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2002 Ford RV Cutaway, 2002 Ford Pickup, 2002 Ford F550 Super Duty, 2002 Ford F450 Super Duty, and 2002 Ford Excursion. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect negative battery cable(s). Remove any component(s) necessary to gain access to PCM. PCM is located on driver's side of firewall. Loosen PCM connector retaining bolt (if equipped). Unplug harness connector from PCM. Remove 2 PCM mounting bolts. Remove PCM cover and PCM. On Econoline, PCM connector and mounting bolts are underhood. On Excursion and F250/F350 SuperDuty Pickup, PCM connector is underhood, PCM mounting bolts are under instrument panel. To install, reverse removal procedure. Tighten bracket bolts and connector bolt to specification. See TORQUE SPECIFICATIONS .

scientia non olet · About LEMON Manuals