LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SVT >> Repair and Diagnosis >> External Pages >> Different car >> Section 81 (Engine Removal, Overhaul & Installation -- ECONOLINE, Excursion & F250-F550 Super Duty - Diesel 7.3L (99F E Series & 99F F450/550)) >> Computerized Engine Controls >> Injector Driver Module >> Removal & Installation (Excursion & Pickup)

Removal & Installation (Excursion & Pickup)

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2002 Ford RV Cutaway, 2002 Ford Pickup, 2002 Ford F550 Super Duty, 2002 Ford F450 Super Duty, and 2002 Ford Excursion. However, it is still accessible from the selected car via links, so may be relevant.

Raise and support vehicle. Remove driver's side front inner fender splash shield. Remove Injector Driver Module (IDM) connector retaining bolt. Unplug harness connector from IDM. Remove 2 IDM mounting bolts. Remove IDM. To install, reverse removal procedure. Tighten bracket bolts and connector bolt to specification. See TORQUE SPECIFICATIONS .

scientia non olet · About LEMON Manuals