Removal and Installation
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, 2006 Ford Cab & Chassis, and 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure can result in major service expense. They must be replaced with the same part number or an equivalent part if replacement is necessary. Do not use a replacement part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of correct retention of these parts.
- Remove the stabilizer bar link lower nut and bushing.
- Discard the nut.
- To install, tighten to 80 Nm (59 lb-ft).
- Remove and discard the stabilizer bar link upper nut, bolt and washer.
- To install, tighten to 150 Nm (111 lb-ft).
- Remove the stabilizer bar link.
- To install, reverse the removal procedure.