Ball Joint: Installation
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, 2006 Ford Cab & Chassis, and 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
- Position the ball joint into the wheel knuckle.
- Using the special tools, install the upper ball joint.
- Using the special tools, install the lower ball joint.
- Install the snap ring in the groove at the bottom of the lower ball joint.
- If removed, install the ball joint grease fitting.
- Install the front wheel spindle or wheel knuckle. For additional information, refer to Wheel Knuckle .
CAUTION:
The grease fitting must be removed from the ball joint prior to installation or damage to the grease fitting can occur.
CAUTION:
To avoid damage to components, do not use heat to aid installation.
NOTE:
Clean the wheel knuckle ball joint bore.
NOTE:
The upper ball joint must be installed first.
CAUTION:
Do not over-tighten the ball joint grease fitting.