LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SVT >> Repair and Diagnosis >> External Pages >> Different car >> Section 130 (ENGINE CONTROLS - SELF-DIAGNOSTICS - 7.3L (995, 996 F650/750, 99F E Series & 99F F450/550) DIESEL) >> System Tests >> Test FJ: Injector Driver Module Feedback >> Diagnostic Aids

Diagnostic Aids

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2003 Ford RV Cutaway, 2003 Ford Pickup, 2003 Ford F550 Super Duty, 2003 Ford F450 Super Duty, and 2003 Ford Excursion. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: After each service or repair procedure has been completed, reconnect all components. Clear DTCs and repeat QUICK TEST  procedures to ensure all electronic engine control systems are working properly and DTCs are no longer present.

Perform this test when directed by QUICK TEST. This test is only intended to diagnose the following components and circuits:

IDM provides EF output signal to PCM to confirm that proper timing/duration of Fuel Delivery Command Signal (FDCS) was received. Additionally, EF signal is used to send diagnostics of IDM and electrical circuits of injectors to PCM.

Fig 1: Identifying Injector Driver Module Electronic Feedback Circuits
G00096692Courtesy of FORD MOTOR CO.
Fig 2: Identifying Injector Driver Module Terminals
G00012106Courtesy of FORD MOTOR CO.