LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SVT >> Repair and Diagnosis >> External Pages >> Different car >> Section 130 (ENGINE CONTROLS - SELF-DIAGNOSTICS - 7.3L (995, 996 F650/750, 99F E Series & 99F F450/550) DIESEL) >> System Tests >> Test Dg: Barometric Pressure Sensor >> Testing

Test Dg: Barometric Pressure Sensor: Testing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2003 Ford RV Cutaway, 2003 Ford Pickup, 2003 Ford F550 Super Duty, 2003 Ford F450 Super Duty, and 2003 Ford Excursion. However, it is still accessible from the selected car via links, so may be relevant.
FAULT CODE SETTING CONDITION

Fault Code KOEO KOER Continuous Memory
P0107
All except F650-750 (1) Test DG  , Step  1)   Test DG  , Step  3)
F650-750 (2) Test DG  , Step  1)   Test DG  , Step  3)
P0108
All except F650-750 (1)(2) Test DG  , Step  2)   Test DG  , Step  4)
F650-750 (2) Test DG  , Step  2)   Test DG  , Step  4)
(1) MIL illuminates when fault is detected in second drive cycle (California, OBD-II calibration).

(2) MIL illuminates when fault is present (Federal).
    NOTE: For additional testing information, see DIAGNOSTIC AIDS .

  1. 1) KOEO DTC P0107: BARO Circuit Low Input
    This DTC indicates BARO sensor circuit low input was detected during KOEO on-demand self-test. Repeat KOEO ON-DEMAND SELF-TEST  under QUICK TEST. If DTC P0107 is present, BARO sensor is defective. Replace PCM. If DTC P0107 is not present, fault is intermittent. If DTC P0107 reappears, replace PCM.
    2. NOTE: For additional testing information, see DIAGNOSTIC AIDS .

  2. 2) KOEO DTC P0108: BARO Circuit High Input
    This DTC indicates BARO sensor circuit high input was detected during KOEO on-demand self-test. Repeat KOEO ON-DEMAND SELF-TEST  under QUICK TEST. If DTC P0108 is present, BARO sensor is defective. Replace PCM. If DTC P0108 is not present, fault is intermittent. If DTC P0108 reappears, replace PCM.
    3. NOTE: For additional testing information, see DIAGNOSTIC AIDS .

  3. 3) Continuous Memory DTC P0107: BARO Circuit Low Input
    This DTC indicates BARO sensor circuit low input was detected during normal operation. Repeat KOEO ON-DEMAND SELF-TEST  under QUICK TEST. If KOEO DTC P0107 is present, BARO sensor is defective. Replace PCM. If KOEO DTC P0107 is not present, fault is intermittent. If DTC P0107 reappears, replace PCM.
    4. NOTE: For additional testing information, see DIAGNOSTIC AIDS .

  4. 4) Continuous Memory DTC P0108: BARO Circuit High Input
    This DTC indicates BARO sensor circuit high input was detected during normal operation. Repeat KOEO ON-DEMAND SELF-TEST  under QUICK TEST. If KOEO DTC P0108 is present, BARO sensor is defective. Replace PCM. Clear DTCs and repeat QUICK TEST . If KOEO DTC P0108 is not present, fault is intermittent. If DTC P0108 resets, replace PCM.
scientia non olet · About LEMON Manuals