LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SVT >> Repair and Diagnosis >> External Pages >> Different car >> Section 130 (ENGINE CONTROLS - SELF-DIAGNOSTICS - 7.3L (995, 996 F650/750, 99F E Series & 99F F450/550) DIESEL) >> Programming Pcm >> Powertrain Control Module Reset >> Resetting Keep Alive Memory (KAM)

Resetting Keep Alive Memory (KAM)

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2003 Ford RV Cutaway, 2003 Ford Pickup, 2003 Ford F550 Super Duty, 2003 Ford F450 Super Duty, and 2003 Ford Excursion. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: This function may not be supported by all scan tools. Refer to scan tool manufacturer's instruction manual.

Resetting Keep Alive Memory will return PCM memory to its default setting. Adaptive learning contents such as idle speed, refueling event, and fuel trim are included. A PCM Reset (described above) is also part of a KAM Reset. Both can be useful in post repair retest.

After Keep Alive Memory has been reset, the vehicle may exhibit certain driveability concerns. It will be necessary to drive the vehicle to allow the PCM to relearn values for optimum driveability and performance.

If an error message is received or the scan tool does not support this function, disconnecting the battery ground cable for a minimum of 5 minutes may be used as an alternative procedure.

scientia non olet · About LEMON Manuals