Restraints Control Module

The Restraints Control Module (RCM) is located on floor pan beneath floor console and contains a microcomputer, which monitors electrical system components and connections. See Figure . RCM performs a system self-check of air bag system internal circuits every time ignition switch is turned to RUN position. RCM also operates AIR BAG warning light during initial system self-check and whenever a system fault is detected. Faults are translated into a Light Flash Code (LFC), which is displayed through flashing of AIR BAG warning light. A LFC is a series of flashes and pauses of the AIR BAG warning light, which represents a 2-digit number and is always displayed at least twice. The RCM also communicates through the Data Link Connector (DLC) current and historical Diagnostic Trouble Codes (DTCs).

If a system fault exists and primary AIR BAG warning light is malfunctioning, RCM uses secondary AIR BAG warning light to indicate need for system service.