Removal (Focus)

WARNING: This page is about a different variant/trim than selected.

Disconnect the battery ground cable.
Drain the cooling system.
Loosen the water pump pulley retaining bolts.

Fig 1: Loosening Water Pump Pulley Retaining Bolts
Courtesy of FORD MOTOR CO.
Remove the accessory drive belt.
Remove the water pump pulley.

Fig 2: Removing Water Pump Pulley
Courtesy of FORD MOTOR CO.
Detach the water pump from the water pump housing.

Fig 3: Detaching Water Pump From Water Pump Housing
Courtesy of FORD MOTOR CO.
Rotate the water pump 180° within the water pump housing and remove it.
- Discard the sealing ring
  
  Fig 4: Removing Water Pump
  Courtesy of FORD MOTOR CO.