LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine - 2.0L Inline - VIN B & 3) >> Removal & Installation >> Water Pump >> Removal (Cougar)

Removal (Cougar)

WARNING: This page is about a different variant/trim than selected.
  1. Drain cooling system. Raise and support vehicle. Remove right wheel. Remove right side lower splash shield. See Figure. Lower vehicle. Loosen water pump pulley bolts (do not remove bolts). See Figure.
  2. Rotate accessory drive belt tensioner clockwise, remove accessory drive belt. See Figure. Remove water pump pulley. Remove water pump bolts, remove water pump. See Figure. Clean gasket mating surfaces.