Removal and Installation

WARNING: This page is about a different variant/trim than selected.

Drain the engine cooling system. For additional information, refer to COOLING SYSTEM DRAINING, FILLING AND BLEEDING .
Raise and support the vehicle. For additional information refer to JACKING & HOISTING .
Remove the lower splash shields.

Fig 1: Removing Lower Splash Shields
Courtesy of FORD MOTOR CO.
Disconnect the lower radiator hose and the Degas return hose.

Fig 2: Disconnecting Lower Radiator Hose & Degas Return Hose
Courtesy of FORD MOTOR CO.
Remove the lower center support bolt.

Fig 3: Removing Lower Center Support Bolt
Courtesy of FORD MOTOR CO.
Lower the vehicle.
Disconnect the remaining coolant hose connections.

Fig 4: Disconnecting Remaining Coolant Hose Connections
Courtesy of FORD MOTOR CO.
Position the hood latch assemble out of the way. .

Fig 5: Removing Hood Latch Assemble Bolt
Courtesy of FORD MOTOR CO.
Remove the two bolts and the center support.

Fig 6: Removing Two Bolts & Center Support
Courtesy of FORD MOTOR CO.
Remove the two top bolts retaining the cooling fan to the radiator.

Fig 7: Removing Two Top Bolts Retaining Cooling Fan To Radiator
Courtesy of FORD MOTOR CO.
Remove the upper radiator support brackets, and remove the radiator from the vehicle.

Fig 8: Removing Upper Radiator Support Brackets
Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.