LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine - 2.0L Inline - VIN B & 3) >> Removal & Installation >> Intake Manifold >> Removal & Installation (Focus)

Removal & Installation (Focus)

WARNING: This page is about a different variant/trim than selected.
  1. Remove cable ties, if necessary. Disconnect battery ground cable. Release fuel pressure. See FUEL PRESSURE RELEASE & FUEL LINE CONNECTIONS . Remove air cleaner housing. Remove Mass Airflow (MAF) sensor connector, crankcase ventilation hose, and intake hose. Disconnect accelerator cable and speed control cable, if equipped. Remove EGR valve and EGR pipe bracket.
  2. Disconnect vacuum hoses from intake manifold. Disconnect fuel injector wiring and Camshaft Position (CMP) sensor. Remove fuel line. Remove intake manifold studs. Remove intake manifold.
  3. To install, clean gasket mating surfaces. Position NEW gasket on intake manifold. Install and tighten bolts/nuts in a crisscross pattern to specification. See TORQUE SPECIFICATIONS . To complete installation, reverse removal procedure.
scientia non olet · About LEMON Manuals