LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine - 2.0L Inline - VIN B & 3) >> Removal & Installation >> Exhaust Manifold >> Removal & Installation (Focus)

Removal & Installation (Focus)

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect negative battery cable. Raise and support vehicle. Remove exhaust manifold bracket. Disconnect HO2S plugs. Lower vehicle. Remove heat shield. Remove air cleaner housing. Disconnect MAF sensor, Position Crankcase Ventilation (PCV) hose, and intake hose.
  2. Remove exhaust manifold from catalytic converter. Remove exhaust manifold from cylinder head. To install, clean gasket mating surfaces. Install NEW gasket and exhaust manifold on cylinder head studs. Tighten manifold nuts to specification. See TORQUE SPECIFICATIONS . To complete installation, reverse removal procedure.
scientia non olet · About LEMON Manuals