Installation (Except Escape & Focus)

WARNING: This page is about a different variant/trim than selected.

To install, Clean gasket mating surfaces. Install new gasket and exhaust manifold on cylinder head studs. Tighten manifold nuts in proper sequence to specification. See Fig 2. See TORQUE SPECIFICATIONS . To complete installation, reverse removal procedure.

Fig 1: Exhaust Manifold Bolt Loosening Sequence (Escort Shown; Escape is Similar)

Courtesy of FORD MOTOR CO.

Fig 2: Exhaust Manifold Bolt Tightening Sequence (Escort Shown; Escape Is Similar)

Courtesy of FORD MOTOR CO.