Cylinder Head: Installation

WARNING: This page is about a different variant/trim than selected.

To install, reverse removal procedure. Ensure crankshaft timing marks are aligned. See Figure. Use Camshaft Alignment Timing Tool (T94P-6256-CH) to ensure alignment of camshafts. Install tool in slots on camshafts at rear of engine. Position NEW cylinder head gasket on cylinder block.
Install cylinder head using NEW cylinder head bolts. Tighten bolts in sequence to specification. See Fig 1 . See TORQUE SPECIFICATIONS .

Fig 1: Cylinder Head Bolt Tightening Sequence
Courtesy of FORD MOTOR CO.
Install camshafts. See CAMSHAFT . Install timing belt. See TIMING BELT . To complete installation, reverse removal procedure. Tighten remaining bolts to specification. See TORQUE SPECIFICATIONS . Fill or top off fluids. Start engine and check for leaks.