LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine - 2.0L Inline - VIN B & 3) >> Removal & Installation >> Crankshaft Rear Oil Seal >> Installation

Crankshaft Rear Oil Seal: Installation

WARNING: This page is about a different variant/trim than selected.

Apply a continuous bead of silicone sealer to rear oil seal housing, and install housing (if removed). Apply engine oil to new oil seal. Using Rear Crankshaft Seal Replacer (T88P-6701-B1) and Crankshaft Rear Seal Pilot (T88P-6701-B2), install rear oil seal. Ensure seal is flush with edge of seal housing. To complete installation, reverse removal procedure. Tighten bolts/nuts to specification. See TORQUE SPECIFICATIONS .

scientia non olet · About LEMON Manuals