LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine - 2.0L Inline - VIN B & 3) >> Removal & Installation >> Camshaft Seals >> Installation

Camshaft Seals: Installation

WARNING: This page is about a different variant/trim than selected.

Thinly coat bearing cap No. 5 with sealant. Install NEW exhaust oil seal. Install bearing cap No. 5. Using Camshaft Seal Replacer (T81P-6292-A), install NEW intake camshaft oil seal. Position oil feed ring hole at top. Check exhaust timing belt pulley installation position. Lug on pulley must locate in hole. Lug is centered between oil bores and oil feed hole. Install timing belt pulleys and lightly install bolts. Install timing belt. See TIMING BELT . To complete installation, reverse removal procedure. Ensure crankshaft and camshafts are aligned. Tighten remaining bolts/nuts to specification. See TORQUE SPECIFICATIONS .

scientia non olet · About LEMON Manuals