LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine - 2.0L Inline - VIN B & 3) >> Overhaul >> Cylinder Head >> Valve Seat

Valve Seat

WARNING: This page is about a different variant/trim than selected.
  1. Inspect valve seat for evidence of roughness or pitting at valve contact surface. Reface seat as necessary. Before refacing valve seats, check valve stem-to-guide clearance. If clearance is not within specification, replace components as necessary. See CYLINDER HEAD  table under ENGINE SPECIFICATIONS.
  2. Ensure valve seat width is within specification. See CYLINDER HEAD  table. If servicing valve seats, valves must be serviced or replaced. Valve seat replacement information is not available from manufacturer.
scientia non olet · About LEMON Manuals