LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine - 2.0L Inline - VIN B & 3) >> Overhaul >> Cylinder Block Assembly >> Crankshaft & Main Bearings

Crankshaft & Main Bearings

WARNING: This page is about a different variant/trim than selected.
  1. Ensure main bearing caps are numbered for location. Ensure main bearing journal is within specification. See CRANKSHAFT, MAIN & CONNECTING ROD BEARINGS  table under ENGINE SPECIFICATIONS. Position crankshaft on "V" blocks. Using a dial indicator, check crankshaft runout. If runout is not within specification, replace crankshaft.
  2. If any bearing clearance cannot be adjusted to standard specification, grind crankshaft and use undersize bearings. Install thrust bearing or number 3 bearing last. Install and tighten main bearing cap bolts in sequence to specification. See Fig 1. See TORQUE SPECIFICATIONS .
Fig 1: Main Bearing Cap Bolt Tightening Sequence (Escort)
G00025268Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals