LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Automatic Transmission - Diagnosis - Cd4E) >> Diagnosis & Testing >> Transmission Solenoid Cycling & Drive Test (Dynamic Test) >> Transmission Tester Removal & Clearing Trouble Codes

Transmission Tester Removal & Clearing Trouble Codes

WARNING: This page is about a different variant/trim than selected.

Disconnect Transmission Tester from transaxle connector. Install vehicle wiring harness to transaxle connector. Install all heat shields that were removed. Disconnect tester power lead from vehicle. See CLEARING DIAGNOSTIC TROUBLE CODES  to erase any DTCs that were set. Run QUICK TEST  to determine if any DTCs are present.

scientia non olet · About LEMON Manuals