LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Automatic Transmission - Diagnosis - Cd4E) >> Diagnosis & Testing >> Transmission Solenoid Cycling & Drive Test (Dynamic Test) >> Preliminary Set Up

Preliminary Set Up

WARNING: This page is about a different variant/trim than selected.

Connect Transaxle Tester (007-0085D). Install pressure gauge to line pressure tap. See HYDRAULIC PRESSURE TESTS under PERFORMANCE TESTS in FORD CD4E (MAZDA LA4A-EL) OVERHAUL article. Set Bench/Drive switch to DRIVE mode. Set tester gear select switch to "1" position. Ensure gearshift lever is in "P" position. Start vehicle.

CAUTION: Transaxle damage will occur if stall test is conducted with EPC switch depressed.
scientia non olet · About LEMON Manuals