LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls - Removal, Overhaul & Installation - CNG/LPG (Bi-Fuel)) >> Fuel System >> Fuel Pressure Regulator >> Removal & Installation (Econoline)

Removal & Installation (Econoline)

WARNING: This page is about a different variant/trim than selected.
NOTE: Fuel pressure regulator and coalescer/fuel filter are removed as an assembly.
  1. Release fuel pressure. See FUEL SYSTEM VENTING . Pinch off coolant hoses approximately 3" from fuel pressure regulator. Disconnect low pressure fuel line from fuel pressure regulator.
  2. Disconnect high pressure fuel line from coalescer/fuel filter. Loosen fitting retaining regulator to coalescer/fuel filter. Remove mounting bracket bolts. Remove regulator assembly. To install, replace natural gas approved "O" rings.
scientia non olet · About LEMON Manuals