F150 (Fuel Tank Solenoid Valve Functions Normally)
WARNING: This page is about a different variant/trim than selected.
- Connect Grounding Cable (134-00121) to back side of the fuel fill valve at the fuel line connection. See Fig 1. Connect grounding cable to ground rod. Turn in the manual lockdown valve jackscrew on the fuel tank solenoid valve(s). See Figure. Connect Fuel Filler Neck Venting Kit (134-00117) to the fuel filler valve. See Fig 2. Connect Venting Hose (134-00118) to the fuel filler neck venting kit. Connect the venting hose assembly to an approved vent stack.
- Remove fuel pump relay from battery junction box located in engine compartment. Connect a jumper wire between fuel pump relay terminals No. 30 and 87. See Figure and Figure . Slowly open manual lockdown valve jackscrew on fuel tank solenoid valve of the fuel tank to be vented.
- Slowly open manual backflow valve on fuel filler valve. Observe gauge pressure of fuel filler neck venting kit. Pressure should be at tank pressure if fuel tank solenoid valve was identified as functioning normally in solenoid diagnostics. Open bleed valve on the fuel filler neck venting kit slowly and allow contents of fuel tank to vent through vent stack.
- Venting LPG fuel tank may take more than an hour. Close bleed valve on fuel filler neck venting kit, and observe gauge pressure. Pressure should be about zero psi (zero kg/cm2 ). Remove fuel tank solenoid manual lockdown valve. Install Manual Override Tool (134-00050) into fuel tank solenoid of the tank being vented.
- Turn manual override tool jackscrew inward until fuel begins venting. Vent the fuel tank until the fuel flow through vent stack stops. Close the manual backflow valve on fuel filler valve when LPG tank contents have been vented. Perform LPG FUEL SYSTEM PRESSURE RELEASE (FUEL LINE VENTING) procedure.
- Remove manual override tool from LPG fuel tank solenoid valve. Install fuel tank solenoid manual lockdown valve. Turn manual lockdown valve jackscrew inward on fuel tank solenoid valve. Repeat this procedure until all affected tanks are vented.
WARNING:
Ensure the jackscrew in the manual override tool is backed out fully (counterclockwise) before installing into fuel tank solenoid valve. Installation of manual override tool in the venting position will cause natural gas to be released immediately.