LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 997 (Power Steering System -- F150 Pickup) >> Removal And Installation >> Power Steering Pump >> Removal

Power Steering Pump: Removal

WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.

    All vehicles 

  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Release the clamp and disconnect the suction line from the power steering pump.
    • Allow the fluid to drain into a suitable container.
  3. Remove the power steering pump pulley. For additional information, refer to POWER STEERING PUMP PULLEY .
  4. Disconnect the pressure line fitting-to-pump and position the high pressure line aside.
    • Discard the Teflon® seal.
  5. Remove the power steering pump.

    6. 4.6L, 5.4L engines 

  6. Remove the 3 power steering pump bolts.

    7. 4.2L engine 

  7. Remove the 4 power steering pump bolts.
scientia non olet · About LEMON Manuals